差别

这里会显示出您选择的修订版和当前版本之间的差别。

到此差别页面的链接

两侧同时换到之前的修订记录 前一修订版
后一修订版		 前一修订版
developmentboard:esp32-c3-eye [2025/10/25 14:48] – admindevelopmentboard:esp32-c3-eye [2025/10/25 14:49] (当前版本) – admin
行 30: 行 30:
 </blockquote> </blockquote>
 {{:developmentboard:eye-1-1.png|}} {{:developmentboard:eye-1-1.png|}}
- 
- 
- 
- 
- 
- 
-{{:developmentboard:eye-4.png|}} 
-{{:developmentboard:eye-5.png|}} 
- 
  
 2.2 Bluetooth Control via Cozylife 2.2 Bluetooth Control via Cozylife
行 92: 行 83:
  
 ==== 3.3.4 Eye Pupil Effect Settings ==== ==== 3.3.4 Eye Pupil Effect Settings ====
- 
-![img](Eye Pupil:) 
  
 ==== 3.3.5 Eye Emotion Effect Settings ==== ==== 3.3.5 Eye Emotion Effect Settings ====
  
 Click the **Auto Emotion**  switch to enable linkage with Xiaozhi's emotions, serving as Xiaozhi's eyes.![img](Auto Emotion) Click the **Auto Emotion**  switch to enable linkage with Xiaozhi's emotions, serving as Xiaozhi's eyes.![img](Auto Emotion)
-{{:developmentboard:eye-4.png|}}+ 
 +{{:developmentboard:eye-5.png|}}
  
 ==== 3.3.6 Eye Auto-Blink Effect Settings ==== ==== 3.3.6 Eye Auto-Blink Effect Settings ====
行 118: 行 108:
 ---- ----
  
-===== V. Frequently Asked Questions ===== 
- 
-==== How to Upgrade the Firmware ==== 
- 
-Upgrade the firmware using the official flashing tool by following these steps: 
- 
-  - Download the Flash download tool. For detailed information about the tool, refer to the doc folder in the compressed package. 
-  - Open the Flash download tool. 
-  - Select the chip type (here, select **ESP32-C3**). 
-  - Choose an operating mode according to your needs (here, select **"develop"**). 
-  - Select a download interface according to your needs (here, select **"uart"**).![img](DOWNLOAD T… ESP32C3 chipType: develop workMode: uart loadMode: OK) 
-  - Select the firmware file, enter the flashing address, and select the serial port in sequence. 
-  - Click **"START"**  to flash the firmware to the device, and wait for the progress bar to complete to finish the flashing.![img](ESP32C3 FLASH DOWNLOAD TOOL V3.9.8 SPIDownload chipInfoDump Note: Please check!!! 1. Select the firmware file 2. Enter the flashing address ⋮ SPIFlashConfig SPI SPEED DetectedInfo SPI MODE DoNotChgBin QIO 40MHz LockSettings 26.7MHz QOUT CombineBin 20MHz DIO Default DOUT 80MHz FASTRD 4. Click to flash DownloadPanel 1 3. Select the corresponding serial port IDLE Waiting COM: START STOP ERASE BAUD: 115200) 
  
  
  • developmentboard/esp32-c3-eye.1761403704.txt.gz
  • 最后更改: 2025/10/25 14:48
  • 由 admin