差别
这里会显示出您选择的修订版和当前版本之间的差别。
| 两侧同时换到之前的修订记录 前一修订版 后一修订版 | 前一修订版 | ||
| developmentboard:ble-33 [2024/04/11 11:46] – admin12 | developmentboard:ble-33 [2024/04/15 10:40] (当前版本) – [1.Hardware preparation] admin | ||
|---|---|---|---|
| 行 8: | 行 8: | ||
| ===== 1.Hardware preparation ===== | ===== 1.Hardware preparation ===== | ||
| - | Prepare a data cable (note: capable of data communication!). The main body of the development board is as follows: | + | **Notice** |
| - | Same as Nano33 Ble: same Pinout pin layout, same RGB three-color LED, factory preset Nano 33 Ble Bootloader Differences from Nano 33 Ble: Added lithium battery charging management, the back pad can adjust the charging current (default 100ma, short circuit 500ma) Reserved sensor pin package (no device attached): MP34DT06JTR (microphone) Sensor pin packages are not reserved (but related pin pads are lead out): LPS22 (pressure sensor), LSM9DS1 (accelerometer gyroscope), HTS221 (humidity sensor) sensor), APDS-9960 (gesture sensor) | + | === Same as Nano33 Ble: === |
| + | |||
| + | same Pinout pin layout, same RGB three-color LED, factory preset Nano 33 Ble Bootloader | ||
| + | |||
| + | === Differences from Nano 33 Ble: === | ||
| + | |||
| + | Added lithium battery charging management, the back pad can adjust the charging current (default 100ma, short circuit 500ma) Reserved sensor pin package (no device attached): MP34DT06JTR (microphone) Sensor pin packages are not reserved (but related pin pads are lead out): LPS22 (pressure sensor), LSM9DS1 (accelerometer gyroscope), HTS221 (humidity sensor) sensor), APDS-9960 (gesture sensor) | ||
| {{: | {{: | ||
| 行 18: | 行 24: | ||
| Note: | Note: | ||
| - | B-:Lithium battery 3.7V- | + | **B-**:Lithium battery 3.7V- |
| - | B+:Lithium battery 3.7V+ | + | **B+**:Lithium battery 3.7V+ |
| **MAXIMUM** Output current per pin is 15mA | **MAXIMUM** Output current per pin is 15mA | ||
| 行 31: | 行 37: | ||
| **Note:** CIPO/COPI was formerly known as MISO/MOSI | **Note:** CIPO/COPI was formerly known as MISO/MOSI | ||
| - | |||
| === Charging current selection jumper: === | === Charging current selection jumper: === | ||